SDRmm

Operate

Direction finding

Compute live bearings from an Array, steer a Beamformer, and triangulate transmitters on the map.

On this page
ArrayCalibrated UCA/ULADirection finderCapon / MUSICBeamformerSteered listeningTriangulationMulti-bearing fixMapRays, heat & ellipsearrayarraybearingeventseventsevents

Direction finder

Wire a calibrated Array (with GPS position) → Direction finder, set Offset and Width, and pick a Method:

  • Bartlett: robust beam scan.
  • Capon: sharper beam scan.
  • MUSIC: resolves close emitters.
  • Root-MUSIC / ESPRIT: grid-free (ULA or UCA only).

Sources auto-counts emitters or takes a fixed count; More adds multipath Smooth and Yaw gate. Wire bearing → Beamformer steer to listen toward the signal.

Direction finder status chips
Chip Means
Squelch Peak below Squelch threshold
No heading / No position Missing GPS or heading on Array
Aliased / Mode alias Element spacing > λ/2 or too high for UCA phase modes
Mirror ULA front/back ambiguity (pick Side)
Rotating Exceeded Yaw gate (blocks skipped)
Singular / Table off / Stale Covariance failed, outside cal table, or 3 missed reports

Triangulate

Wire events from one or more Direction finders (or a Signal hunt sweep) to Triangulation, and wire both to Map for rays, heat layer, fix, and 1-sigma ellipse.

  • Align: learns a fixed mount heading offset once a loop/crossing pins it down.
  • Fade: ages old bearings (Auto picks Fixed/Moving, or Set half-life). Min conf / Emitters filter noise and cap targets.
  • Guidance: wire vehicle GPS to position (Drive across / Drive at it; Guide Auto/Direct/Off, Probe cross distance). In a car with a phone, bearings pause while turning and down-weight sudden fades; cross from a second road angle to defeat multipath.

Edit this page on GitHub

Esc