SDRmm

Operate

Transmit

Arm safely, send APRS, talk over NFM/AM/SSB with PTT or VOX, or relay baseband and lanes.

On this page
MicrophonePTT or VOXNFM encoderAudio FX + limiterTransmitterArm, level & timeoutDeviceUse = Send or Bothaudiobasebandtransmit

Radios that send

Set Device Use to Send or Both (Receive never keys TX). TX gain lives on the Device; transmit frequency must lie inside the Device’s active window.

Radio Duplex Notes
HackRF One Half RX pauses per burst; +14 dB Amp shared by RX/TX
ADALM-Pluto, AntSDR Full Per-lane TX attenuation
Aaronia SPECTRAN V6 Half RX pauses while sending
bladeRF, LimeSDR, USRP (Soapy) Per board Shared TX gain elements
Virtual Transceiver / Half-duplex Full / half Debug builds; other virtual radios hear it

Ways to feed a Transmitter

  • Message (e.g. APRS): Encoder baseband → Transmitter → Device transmit. Set frequency (empty = Device centre), Arm, press Send.
  • Voice (NFM / AM / SSB): Microphone audio → Encoder → Transmitter → Device. Hold key (or Space) for PTT, or enable VOX. Wiring another channel’s audio builds a squelch-keyed relay. Voice encoders include the Audio FX chain plus a hard modulation limiter.
  • Channel / lane relay: wire channel baseband or Device iq directly into Transmitter (always set an offset frequency unless antennas are isolated).

Level, timeout, and width

  • Level: keep several dB below full scale.
  • Timeout: caps single burst duration, disarming if exceeded.
  • Width: 99% occupied bandwidth of the last burst; warns amber if wider than the mode’s channel (lower level/audio). Rewiring an armed Transmitter takes it off the air.

Edit this page on GitHub

Esc